 |
|
The Patriot Shear
Product Description
| • |
Notch, Punch, and Cut-off Die on Aluminum Plates |
| • |
Servo Drive Assembly with Alpha Gear Reducer |
| • |
Encoder bracket and Overrun Clutch |
| • |
Short Part Conveyor Belts |
| • |
Variable Speed Drive |
Advantages
| • |
Servo accelerated Punch/Notch & Shear Die allows for close coupling with Rollformer minimizing floor space requirements |
| • |
Entry cascade with individually adjusted lead-in guide |
| • |
Entry straightener with pinch rolls |
| • |
Punching, Notching, and Shearing for variable width panel sections |
| • |
Material does not stop for Punching/Notching & Shearing, the result is greater net output of finished product |
| • |
Integrated slug capture tray (bin by customer) |
| • |
Dual timing belt, servo acceleration system |
| • |
Two operations in one acceleration move |
|
Click On Photos To Enlarge |
| Standing Seam Roof Panel Line |
Material |
Pre-Painted, Galvalume, & Galvanized CRS |
Material Strength SSR |
70,000 PSI Yield Maximum (Grade “D”)
50,000 PSI Yield Minimum (Grade “D”) |
Material Strength Building Panel |
80,000 PSI Yield Minimum (Grade “E”)
50,000 PSI Yield Minimum (Grade “D”) |
Thickness SSR |
.030" Maximum, .018" Minimum
22 - 26 Gauge (approximately) |
Thickness Building Panel |
.035" Maximum, .017 Minimum
22 - 29 Gauge (approximately) |
Rollformer Speed |
50 to 200 FPM Variable Speed |
Mode of Operation |
Flying Prepunch/Prenotch/Precut |
Cut Length - Precut |
42" Minimum CTL @ 100 FPM
6' Minimum CTL @ 1200 FPM
100 FPM Maximum for Punch/Notch/Cutoff |
| Length Tolerance |
+/- 1/8" @ 50' length @ 200 FPM |
| Flying Hydraulic Punch / Notch Shear Technical Data |
|
Includes shear and punch / notch units. Mounting holes
and slug clearance for lead/trail hole punching
included. Punch / notch and cutoff die (48"
capable).
|
Cutoff |
Mounted on shear bolster
|
Hydraulic System |
Dedicated hydraulic power unit |
Panel Capacity |
48" total blade width |
Speed |
200 FPM maximum speed – Cut Only
100 FPM maximum speed – Notch and Cut |
Cycle Rate |
20 Cuts per minute maximum punch for Cut Only
10 cuts per minute maximum for punch / notch one end and cut |
Cut Length without Notch |
40" Minimum, 10' (and longer) @ 200 FPM |
Length Tolerance |
+/- 1/8" |
| Passline |
42" Nominal |
|
|
 |
|
